Guide To – Measuring for a Cock Ring

cock

 


Measuring for a Cock Ring


 

You wouldn’t go buying an engagement ring without first checking its the right size and cock rings are no different, it’s not a one size fits all deal. This is one of those times when cock size really does matter.

Sure, you can get one size fits all cock rings that are stretchy, but just like those cheap one size fits all slippers they just won’t be as comfortable or snug.

So How Do You Measure?

cock sizing 1

For the perfect fit it is best that you measure yourself properly, take a measuring tape one of the flexible ones, wrap it around your erect penis at the base where it meets your body.  (as shown in illustration)

It is recommended that you do this several times to make sure you are getting the correct measurement, even just a few mm makes all the difference, so take your time and don’t rush this.

If you don’t have a flexible measuring tape then grab a piece of string, wrap this around the same area and mark it. You should do this several times, just like you would if you are using a measuring tape. One you are done marking lay the string out flat and measure the length using a ruler or non-flexible tape measure.

Most cock rings are measured in diameter, so to get your size you have to do a quick conversion. Take your size in inches and then divide this number by 3.14. The number you get will be your cock diameter.

Here are a few examples :

3 inches divided by 3.14 = 0.95 diameter

5 inches divided by 3.14 = 1.59 diameter

7 inches divided by 3.14 = 2.22 diameter

You will want to buy a cock ring that is just slightly smaller than this size but don’t go too small as this may be a little too restrictive.

cock sizing 2

 

If you want to measure for a cock and ball ring, then you will follow the same instructions with one difference.

You will want to measure yourself from the base of your shaft where your cock meets your body around the back of your balls as shown in the illustration.

Remember to measure this several times to make sure you’re getting an accurate reading.

 

 

Fitting

Cock rings come in different materials, if you are buying one that is adjustable then check the maximum and minimum measurements, if your measurement falls between them, the cock ring will fit you.

Other types of cock ring may be rigid such as those made from metal, when buying a metal cock ring it will have to be 0.25 inches -0.5 inches smaller than your own diameter measurement to ensure a nice snug fit without being too constrictive.

When using metal/rigid cock rings or cock and ball rings, position onto a flaccid penis before you get erect.

Safety First

It’s really important that you measure correctly as this allows for the best and most beneficial fit. It’s especially important when buying metal cock rings as these are a lot more restrictive and harder to remove in a hurry if there is any discomfort felt.

Metal cock rings are not recommended for beginners as these are a lot more constrictive, so the sensations will be very intense, they cannot be stretched, pulled off or cut so bear this in mind.

If you feel any sharp pains or discomfort remove the cock ring and check your sizes again.

Cock rings restrict the blood flow to the area, so you should never wear a cock ring for more than 20-30 mins at any one time.

The Oooh! Review twitter banner

 

I am not an expert, always seek professional help where applicable. The opinions on this post are my own, this post has been written from my personal experience or knowledge. I do not take any responsibility if my advice or the products I recommend don’t work for you. Everyone is different therefore it is impossible for me to know if the product or advice I give will suit your needs. These are just my personal experiences and accounts, and are intended to be used only as a reference. Some of the products I test are made from porous (non- body safe materials). To check if a product is safe please see HERE
 

 

One thought on “Guide To – Measuring for a Cock Ring

Leave a Reply